Skip to content

Case studies

Ideas we turned into hardware.

The brief, the decisions behind each board, and what shipped — from hotel automation to robotics to our own product.

Hospitality · [CLIENT / HOTEL]

A wireless Do-Not-Disturb system for hotel rooms

Guests set Do-Not-Disturb or Make-Up-Room with a touch inside the room; the door unit lights up for housekeeping. Three boards, linked by LoRa radio instead of new wiring.

3 boardsCH32V003 RISC-VLoRa 868 MHzCapacitive touchMains powered
Inside Main board of the hotel DND system, 3D render with components

The brief

The hotel needed guests to signal Do-Not-Disturb or Make-Up-Room from inside the room, with a clear indicator outside the door for housekeeping — fitted into existing rooms without running new cable between the bedside and the door. [Add the client’s exact brief and constraints.]

What we built

Inside Main2-layer · 80 × 80 mm

In-room controller: CH32V003 MCU, RFM95W LoRa radio, on-board 230 V AC supply with fuse and surge varistor, relay output and buzzer.

Inside TouchTouch panel

Two TTP223 capacitive touch keys with red and green status LEDs — no mechanical buttons to wear out or trap dirt.

Door UnitOutside the door

Second CH32V003 and LoRa radio, 16-LED indicator driven by a MOSFET for even brightness, its own mains supply and a touch key.

Engineering decisions

  • LoRa between door and room. Two RFM95W radios replace a cable run through walls, so retrofits need only a mains point at each end.
  • A low-cost RISC-V MCU. CH32V003 on both ends keeps the bill of materials low for a product sold per room.
  • Safety on every mains board. HLK-PM01 isolated supply, 1 A fuse and 470 V varistor for surge protection.
  • Touch, not switches. Sealed capacitive keys behind the panel suit hotel cleaning routines.

Outcome

[X]

rooms installed

[X] wks

brief to pilot

[X]

revisions

[What changed for the hotel — e.g. fewer guest disturbances, faster room turnaround, staff feedback.]

Your product could be the next story.

Start a project →